I dont feel offended at all Sunshine! I appreciate your willingness to help! I mean, I was literally playing for less than 5 minutes through my one amp (4ohms) and it was sounding great!! I switched over to my Ampeg (SVT 810E @ 4ohms nominal impedence using a mono plug) and the volume was very low.
When you switch back to the other cab it is still lower volume than it was before?
I then switched back to my Peavey 215 and the volume was still low
Is your main volume knob linked to the monitor volume?
Hm, not sure, still familiarizing myself with the setup, but I went in to all of the volume things I could find and set everything at 0.0, and the volume will NOT go up very much.
Did you change the power amp boost settings?
I have been looking for that, but no, I haven't physically changed anything. I just downloaded the manual, because I'm not sure where to find that.Was there any popping noises when switching the cabs?NopeWhat is the impedance of the first and second cab?Both at 4ohms
You are sure you are plugged back in to the powered monitor out when swapping the cabs?
I didn't change the plug coming from the Kemper, only where it was going to the input of the cab, using the same cable - the one that was working FINE just a few moments prior.
Have you tried a different speaker cable?
No, I will.
I will report back.