Kept hearing about these dirty Shirley profiles so I downloaded them.
Put them in my shared folder on my USB stick, put it in the Kemper, hit the load button and waited the 10 minutes or so it takes to load and after all that, they aren't there.
What am I doing wrong?
New profiles not loading up?
- Glowing_Tubes
- Closed
- Thread is marked as Resolved.
-
-
Did you browse with the correct tag? Either "Last Imported" or "All"?
Btw, delete all other rigs on the stick before importing. Should be quick to import new rigs then!
-
Ok, cleaned the USB drive of all profiles.
Put about 10 or so on there.
Put it in the kemper. Hit external files button, hit import.
It's been about 10 minutes and the Kemper is frozen on the sharing files menu page. (does this every time now)
My usb stick has a little light in it that indicates it's being read but this should not take so long should it?I had checked both with the "All" and the "last import" tag but the files were not on there.
Thanks again.
-
I advise to use another USB-Stick, perhaps you've got a hardware problem in the stick.
Formatting the stick by the KPA is also required. -
if everything is working correctly then importing a small number of new profiles should take about 10 secs.
-
if everything is working correctly then importing a small number of new profiles should take about 10 secs.
right.
please try formating the usb stick in the profiler.
remove all files before, since all data will be deleted.then try again.
thanks.
-
right.
please try formating the usb stick in the profiler.
remove all files before, since all data will be deleted.then try again.
thanks.
Thanks for the tip, I'll try that.
-
reformatting worked. Thank you!