Is there anything out there that can do this? If not i REALLY don't understand the enormous holdup with the Kemper footswitch. My bands KPA's will be in a rack out of sight, going to have to change patchs from memory and hope we get it right.
Foot controller with patch/slot names?
- chamelious
- Closed
- Thread is marked as Resolved.
-
Last official word on this was 'not before Q1/2014’.
-
-
In the meantime, what about writing the patch numbers on your set list? If you're using Performance Mode this gets even easier, since you'd just have to write the Performance number, and then you could organize your tones so that, say, pedal 1 is always your clean, 2 is your rhythm, 3 is your lead, etc.
-
In the meantime, what about writing the patch numbers on your set list? If you're using Performance Mode this gets even easier, since you'd just have to write the Performance number, and then you could organize your tones so that, say, pedal 1 is always your clean, 2 is your rhythm, 3 is your lead, etc.
This is what i'm doing. Its just a bit of a low-fi/risky/rubbish solution for such an expensive device.
