Dear all.
I am aware I am going to créate a new issue really difficult to solve.
From the beginning, my F C B doesn't save the changes I edit. When I switch OFF / ON the device, all the edited parameters are missing and they've backed to the default factory values. 
I was working with original EPROM V2.2 but I replaced it for EPROM UnO_4_KEMPER (V1.2, the last one) and the problem keeps.
Can anybody help me? perhaps changing any electronic component.... I don't know.
So doe's the Uno4kemper ( its pre configured) work with your kpa 
For clarity what parameters are you referring too?
Pedal assignments and now expression pedal sweep curves are all you can do.
You think YOU got problems. I can't even FIND one of these units right now. Everyone selling their beat up one thinks it should go for the price of new, and even then without the power supply?!?
Just complaining, don't mind me. Hi-Jack over....
You think YOU got problems. I can't even FIND one of these units right now. Everyone selling their beat up one thinks it should go for the price of new, and even then without the power supply?!?
Just complaining, don't mind me. Hi-Jack over....
The Fcb1010 has a internal power supply! unless you mod it.
How does it get it's power?
I said that because I saw an eBay that said "No power supply" so I assumed it originally came with one.
Sort of like saying "Selling Kemper without Guitar" lol
How does it get it's power?
I said that because I saw an eBay that said "No power supply" so I assumed it originally came with one.
Sort of like saying "Selling Kemper without Guitar" lol
standard Power cored. 
Hey you hi-jackers, try and give some useful answer to the OP! 
There seems to me based on the info the op provide
That both chips he has used in the FCB won't save settings
we need to find out if the settings are stored on the firmware chip or on a pedal board chip.
So contact the Uno4kemper people and ask them some question.
Could be a battery problem. Open up the back, look for the battery and replace. You should be golden.
So contact the Uno4kemper people and ask them some question.
I already answered that question through email to the OP on Jan. 02
------------------------------------
Hi,
if your settings are not retained, the eeprom which stores these
settings is defective. It's a cheap component but you will need to
bring your FCB1010 to a repair center to have it replaced.
regards,
Xavier
------------------------------------
Could be a battery problem. Open up the back, look for the battery and replace. You should be golden.
Sorry, the FCB1010 doesn't contain any battery - and it takes a LOT of screws to remove before you find out... 
Display More
Quoted from "nightlight"
Could be a battery problem. Open up the back, look for the battery and replace. You should be golden.
Sorry, the FCB1010 doesn't contain any battery - and it takes a LOT of screws to remove before you find out...
Lol! Thanks for the quick rebuttal. OP might have gone crazy following my advice!
