Anyone else noticing this with 2.3? Pick any amp (cleans in particular), and play a little, then go into the amp block and adjust the clarity setting, the sound suddenly changes with a noticeable click, sometimes getting a tad muffled. Rotating the dial back to the previous point doesn't bring back the sound as it was before.
Click and change in sound on use of Clarity control
- Per
- Closed
- Thread is marked as Resolved.
-
-
Just a note, this only occurs if the original rig has the clarity setting at 0.0. Switching away from the rig and back again will return the sound to where it was (until you go in and edit the clarity setting again).
-
Yes, I've seen the same thing. Moving from 0.0 makes a noticeable sound, and then the rig seems darker than it was. Switching to another rig, and then back, restores the original brightness.
-
With 2.3, I encountered this behavior as well.
-
I found 2.3 clearer but i must be the only one.
-
-
This is still happening for me (although to a lesser extent) in 2.3.1