I am thinking of getting either a single or a pair of DXR 10 or 12. My question is, how do you connect the speakers? Do you use main outs (two speakers)? Or, if you use only one, does it go with the monitor out? Would one be enough to use as stage monitor (monitor out). I would like to have loudness and tone control on stage. Different loudness between FOH and stage.
DXR 10 or DXR 12 - How do you use them?
- Bluesman
- Closed
- Thread is marked as Resolved.
-
-
Hey Bluesman,
i am using a single DXR10 (many here say that it sounds better for typical guitar sounds than the DxR12). I don't use stereo effects so i hook up a DI-Box (mounted in my rack) to the monitor out and from there i use a XLR cable to connect the DXR10. The monitor out has its own volume setting (separated from main out volume) and also its own 3-band EQ. One of the main outs go to the FOH.
Using a stereo setup is a different story, I never use it, maybe somebody else can give some info about it... -
I used to use 2 DXR10's before I went IEM's they sound great and I used to feed them a stereo signal from the main outs of the KPA
-
I use them in stereo, with monitor out and direct out. look at this thread I opened yesterday
http://www.kemper-amps.com/for…a-DXR10-How-to-solve-it/? -
I have two DXR10 bit I only use one live via Monitor out.
The sound I get on stage is absolutely glorious, -
I use one of the Main Outs to the DXR10, and the output XLR of the DXR10 goes to the PA.