Not connected my Powerrack properly to a PA yet. Can someone just confirm it's a simple as using the main outputs as this is what the manual says.
I assume it's ok to use one output as mono ( not using stereo effects) and it would sound OK?
I would like to just take the mike lead at a gig and just plug into the back.
No setting changes required except perhaps monitor cab switch??
The reason I ask is I did quickly connect to PA and it sounded awful ( distorted and thin). However, it was a "crap" PA and didn't check levels etc so I assume it was this but just wanted to check the fundamentals first.
Also, I assumed that to run and FRFR speaker ( typically a monitor, I would go passive and use the power amp which is then the speaker output?