merged profiles don`t work...

I think it's because the DA profile is only sent through Monitor Out with the option checked in the Output menu. Switching the Cab off on the front of the profiler engages the CabDriver algorithm, I suspect. Correct me if I'm wrong, @ckemper

This is what the manual states about switching off the cab of a Merged profile.

"If you switch off the Cabinet Module, you will get the authentic, "amp only" sound of the Working with Amplifier Profiles, Cabinet Profiles, power amps and real cabinets 18 Direct Amp Profile to be fed into a physical guitar cabinet."

Quote from artembankin

pacocito

but sound on my screens not "autenthic and "amp only" ...
this is same sound from old - unmerged profiles....

what i`m doin wrong ?

sambrox
profiles sent to monitors out - sound same ...i checked ...

Display More

Hi. I was answering to Sam about disabling the Cab with merged profiles. The manual states that disabling the cab must work.

I will try to make some merged profiles and check the differences between DI vs Merged with cab off and Studio vs Merged. I'll post my test here.