Has anyone else had hangups when scrolling through cabinets or rigs? I was going through some cabinets and the scrolling hung up. I switched to tuner, but that didn't kick it out. Switched rigs with the pedal and eventually it came out of it. The rig switch was instant, but the screen didn't come out immediately. Curious if it was only a moment in time or if others have seen anything like this.
3.2.1 Hangup
- bshaw92
- Thread is marked as Resolved.
-
-
hangups when reordering performences, and browsing rigs in browse mode.. one time I just had to switch it off, because no knobs was working. I thought it was because after installing TAF finalpack and got 975 rigs..
-
Hi bshaw92
I have problems since FW 3.2 and also with 3.2.1
Switching is sometimes slower. Sometimes KPA is freezing,
sound is still there but I can't do anything. Only power off.
I have the problems only if RigManager is connected.
Kemper support can not reproduce the problem
Using RigManager on a Win 10/64bit notebook. -
I've had Rigmanager crash a few days ago and the same happened. The kemper still produced sounds but no buttons responded until I turned it off and back on again
-
3.2.1 is slow ,period .
It took two seconds (or even more) in Performance mode to change from one to another rig .Do something
-
Do something
Guys, please be sure to open support tickets, so Kemper team will know abut these issues.
Posting it on forum is not enough for solution. -
Guys, please be sure to open support tickets, so Kemper team will know abut these issues.
Posting it on forum is not enough for solution.This is so true, I've had no bad experiences with 3.2.1 done 2 gigs with it at the weekend. just make sure you open a support ticket and send a backup this helps the KPA narrow down any bugs that maybe happening.
-
Performance mode : if I change Reverb parameters in slot number one say , after saving , ALL the slots are saved with he same Reverb as in number one slot .
It becomes annoying ...
Is this about 3.2.1 bug or something else ???
Thanks ! -
Performance mode : if I change Reverb parameters in slot number one say , after saving , ALL the slots are saved with he same Reverb as in number one slot .
It becomes annoying ...
Is this about 3.2.1 bug or something else ???
Thanks !Loos like a bug, please raise a ticket for that at http://www.kemper-amps.com/contact
-
last week two times total lock up in performance mode. had to start up again because pushing buttons didn't work anymore.
-
Performance mode : if I change Reverb parameters in slot number one say , after saving , ALL the slots are saved with he same Reverb as in number one slot .
It becomes annoying ...
Is this about 3.2.1 bug or something else ???
Thanks !Are you sure you don't have the reverb block locked?
-
thanks for the hint Doug ,will check it out tonight ...
EDIT , just checked ,an yes ,Reverb was locked .......
You was right ......I was stupid -
thanks for the hint Doug ,will check it out tonight ...
EDIT , just checked ,an yes ,Reverb was locked .......
You was right ......I was stupidHaha, happens to the best of us. Somehow I had the input block unlocked at one point. Hadn't gone into it in weeks and just... for some reason, everything sounded different. Turns out there were greatly varying values for clean sense instead of a standard, across the board value. ¯\_(ツ)_/¯