Hi everyone,
Yesterday, I suddenly started to get an "software error" message when I turn to "perform". (see attached picture.) All the other functions works fine, and there´s never been a problem with the rigs before. I´m on the 3.0.2. firmware.
Have anyone experienced this? Can anyone help me out here? 
Much appreciated.
No experience - but you did send it to support, right?
If not, see mi signature for a link. Or write directly at [email protected]
Like Michael states when you see something like this it's always good practise to contact support
To fix this please start the Profiler into Browse mode while pressing down the RIG button until you see "Initialising current rig" in the display.
Thank you very much hjscheffler, this worked! 
And thank you everyone else too, for your reply.
I have this same issue, turned on tonight for the first time since Sunday and keep getting this message when turning on.
I have this same issue, turned on tonight for the first time since Sunday and keep getting this message when turning on.
Have you tried the RIG button reset like suggested earlier in this thread?
Have you tried the RIG button reset like suggested earlier in this thread?
Yes, that resolved the issue. Thanks.
