Since OS 5.1 my Profiler always starts in Tuner Mode, though the knob is switched to Browse- or performance-mode. Can this be changed ?
Tuner after Start - SOLVED
- Hurricane
- Thread is marked as Resolved.
-
-
Do you have a pedalboard connected?
-
No, I'm using the Kemper-Remote !
-
Check the tuner parameter in system menue
-
Did it solve your problem?
-
Not yet. I'm still at work. I'll give it a try this evening.
-
Did it solve your problem?
Nope !
There's no soft button or anything else in the system-menu to switch on or off. -
Nope !There's no soft button or anything else in the system-menu to switch on or off.
Yes, sorry it isnt. What are your settings in tuner menue?Mine are mute tuner is setted and Tuner volume 0n is setted.
-
Same Problem here.
-
Maybe its time for a support ticket
-
Maybe its time for a support ticket
Doesn't your Profiler start with Tuner-Mode on ?
-
Is your issue that the tuner mode shows up briefly after the startup screen before it goes into whatever other mode is selected?
-
No, it stays constantly in tuner mode. Even when switching to f.e. performance mode and back again or to tuner-mode (via Hardware-knob) and back again.
After "switching off" the tuner via my Mission-Expression-Pedal , which is linked to the Remote, all is as usual.
It occurs just only after starting the Profiler. -
Doesn't your Profiler start with Tuner-Mode on ?
I start my kpa in browser or performance mode and the tuner is not shown. Tuner appears only when my volume pedal is off.
-
Is it your expression pedal (volume) right down so going into tuner mode?
-
No, it stays constantly in tuner mode. Even when switching to f.e. performance mode and back again or to tuner-mode (via Hardware-knob) and back again.
After "switching off" the tuner via my Mission-Expression-Pedal , which is linked to the Remote, all is as usual.
It occurs just only after starting the Profiler.In that case please send an email to [email protected]
-
Is it your expression pedal (volume) right down so going into tuner mode?
I know what you mean, but No That' what I checked First
-
In that case please send an email to [email protected]
I'll send you my Last Backup, thanks
-
I'll send you my Last Backup, thanks
Interesting. Keep us informed.
-
I think I have the same problem:
OS 5.1.1
Remote connected.
On pedal 4 connector of the remote: stereo cable with ring to switch the Looper Mode and tip to switch Tuner.
The 2 switches are normally open.Polarity of Looper Switch: reverse polarity (otherwise I start in Looper mode...)
Polarity of Tuner Switch: normal polarity (when I choose reverse polarity: the switch doesn't work at all...)When I start up the Kemper, it's shows for 5 seconds the normal performance but then the Tuner appears. When with I switch off the Tuner, everything works normal.