Hi
I was inspired buy some profiles i saw recently then claim to have been run through tape and thought I would try the same with my Ampex 440C.
Only issue is the delay between the record and playback heads is actually mimicked by the profiler so anything I profile this way has a approx 166ms delay/latency.
Is there a way to eliminate this delay ?
latency like this is normally automatically removed in the Profiling process.
please contact me over pm, I'd like to take look at one of the Profiles.
OK thanks I didn't go through with saving the profile but will give another go with this in mind. There was also some noise from the amp that may have picked up so will do again with this in mind. I'll let you know how it goes.
Thanks got it working. Just needed to pump in a bit more gain, something must have been triggering it into thinking it was the intended signal as the profile i noticed bumped up the noise floor quite a lot also.
