Reverb Time might be the parameter you are looking for.
To answer the other question: we have no plans to develop a room capture.
Reverb Time might be the parameter you are looking for.
To answer the other question: we have no plans to develop a room capture.
Reverb Time might be the parameter you are looking for.
To answer the other question: we have no plans to develop a room capture.
Ah I meant more like if the volume were visualized, more of a control to adjust that over time (in the image 4 seconds) like a this :
[Blocked Image: http://www.peranders.com/general/reverbfalloff01.gif]
Which is why I assumed Damping would be it. Because obviously you want a lot of diffusion on the loud (close to the mic) bits, but to stop it overwhelming things to then drop back down further.
I just couldn't seem to nail a sound that was like the room (as you can hear and see in the profiles I provided), with that profile no matter where I adjusted the reverb, but maybe someone else can give it a shot?
Par
Do you profile with that much noise going on????
That would have to skew the profiling?
Its kind of like measuring with micrometer and doing the work with a hand saw....
Bill
Check my previous post (one before last). I think you'll agree the Kemper profiled the noise perfectly, just not the amp at a distance.
My understanding is KPA CAN'T Profile reverb,room sound is a kind of reverb,so Distance Miking is not good?
OR as ck said,it does support it ,but we don't accept the result。