To clarify: Although I am an official KPA beta tester, I will not begin having 'hands on' input until our current tour is over (a bit less than 3 months) From the comments I've heard & the feature list, I believe 1.0.9 is a considerable improvement.
FW. 1.0.9
- guitarnet70
- Closed
- Thread is marked as Resolved.
-
-
Yea I'm digging this update for sure!
CH
-
Found out something again which I'm sure is related to my two other problems... engaging loop into stomp blocks clean sense value to full....
-
Found out something again which I'm sure is related to my two other problems... engaging loop into stomp blocks clean sense value to full....
I cannot recreate this either on mine...
-
I cannot recreate this either on mine...
I think my 3 problems are all related
When I mean to full ..that is you can still adjust it but the volume is the same as full all the time..it won't change
-
You did a reset of the KPA and it didn't change a thing, right?
You also went back to 1.0.8 and reinstalled 1.0.9?I would suggest reporting all 3 problems along with sending a complete backup of your KPA to support...
-
BTW loop selected into X slot doesn't do this
-
You did a reset of the KPA and it didn't change a thing, right?
You also went back to 1.0.8 and reinstalled 1.0.9?I would suggest reporting all 3 problems along with sending a complete backup of your KPA to support...
I even flashed the unit but nothing helped.. I sent a lot of emails to support but no answer
-
I sent a lot of emails to support but no answer
Today is a holiday... they'll be on it tomorrow, I'm sure
-
Clean sense blocked with 1.08 too using a loop in stomp...Another user seems to have clean sense blocked into 1.09 with this
-
Check your PM's Chris thx
-
Gate in loop confirmed by another user..I highly doubt we are only two
-
Can a few others test this and confirm or "the opposite of confirm" it?
-
Can a few others test this and confirm or "the opposite of confirm" it?
That would be nice .. Procedure is easy :
Put a patch cable in send (direct out)/return , select a high gain rig with no gate anywhere..select loop distortion into stomp A and listen..does the noise level change ?
thx
-
We have a noise gate in the loop now. Does it bother you?
-
Mystery solved!
-
We have a noise gate in the loop now. Does it bother you?
Christoph..I sent a message to support yesterday and was told " sorry could not recreate it " LOL
May be it would be good to keep everyone informedWhat about clean sense not responding when loop is selected ?
-
We have a noise gate in the loop now. Does it bother you?
It would be nice to have the option to turn it off.
-
Great update! the new gates are a great addition just need an octave, harmoniser, and an pc/mac editor added to the KPA and I will be UBER happy
-
We have a noise gate in the loop now. Does it bother you?
That's interesting, C!
I upgraded and played last night and the only thing I didn't check was the loop where I have the G- System connected!
That will keep me busy tonight!