Hi fellas,
Just bought a KPA this week and have had a good two days playing around with it (as well as reading the many informative posts here).
Done my first profile today with my Mesa Lonestar Special (in both clean and dirty settings). For general use I'm using the power amp of the LSS (via the loop return) to run the KPA (and turning the 'monitor cab' off on the KPA).
Is it OK to do the following?:
- Guitar into KPA and KPA into the return of the Mesa's effect loop.
- Out of the KPA's direct out into the input of the Mesa
Then could I use the KPA's tones by switching the loop in and lowering the Mesa's channel volumes (but use the master for overall volume control) or switch the Mesa's loop off and therefore be using the Mesa's tones? More of an experiment then anything else.
Looking forward to profiling my Toneking Meteor II next followed by my Cornell Plexi 18/20.