I can't figure out how to change which profile loads upon first powering on/startup of my Profiler.
It's currently set to a profile I don't use much and would like to select a different profile for my startup profile.
thanks in advance.
I can't figure out how to change which profile loads upon first powering on/startup of my Profiler.
It's currently set to a profile I don't use much and would like to select a different profile for my startup profile.
thanks in advance.
?? it loads the last profile you had when you switched off. isn't it?
?? it loads the last profile you had when you switched off. isn't it?
It certainly does in Performance mode.
So, change to performance mode, put your fav rig in a performance slot, and reboot to performance mode and you'll be there.
even in browser mode,
and also with a Rig Not Actually saved into the KPA (i.e. a Rig You temporary loaded with RM preview)
just tested (..Again, to be Super Sure)
I can't figure out how to change which profile loads upon first powering on/startup of my Profiler.
It's currently set to a profile I don't use much and would like to select a different profile for my startup profile.
thanks in advance.
Do you have a MIDI controller connected that sends a specific PC number when it is powered on?
I'm always in Browser mode. It does not load up the last profile I had selected.
It always loads a profile called "Use Your V Knob" and I rarely use that profile.
I'm always in Browser mode. It does not load up the last profile I had selected.
It always loads a profile called "Use Your V Knob" and I rarely use that profile.
With the Kemper in browser mode, open rig manager, then double click on the profile you want (headphone icon shows on the left). Then reboot into browser mode and it'll be there. Worked for me.
as Paul suggested, Do You have anything MIDI connected ?