Need Stereo out to external Power Amp, while using Send for External Loop

1st Official Post

    Hey Fellow Kemper Users.


    We need a Stereo Out to an external Stereo Power Amp,

    and because we use Direct Out/Send for External Loop, I guess we have to use Headphones Out for the Power Amp?



    1: Can the Master Volume knob be set to adjust only Headphones Out? (That will be the guitarists knob for changing level for his cabinets onstage during show)


    2: Can we have the Headphones playing the "Final" signal with all efx and stuff as if it was Monitor Out (but now in Stereo) and not having the dry guitar signal on top of it?


    3: Can we have the Headphones Out without the Cab Simulation that is being used on Main Out? (We have 4 Engl 412-Cabs run by a Stereo Power Amp on stage)


    4: Is there a way to have a Stereo L+R Send out of the Kemper? (We will have Stereo L+R coming back into the Kemper again via Return Input+Alternative Input)

    Or is Mono Send the only option?



    Thank you in advance... :)


    Kent Kox



    Regarding Picture:

    - 2nd Kemper is for spare (with same rigs and settings loaded as the Main one.

    - Top GXC Switcher is for up to 8 Mono Pedals before going into the Kemper Input.

    - Bottom GXC Switcher is for up to 4 Stereo Pedals to be inserted into the Kemper Send/Return Loop.


    Thanx alot


    So not possible to take off cab sim on headphones, if Main Out xlr has the Cab sim On ?



    Kent

    • Official Post

    No!


    With a PROFILER Stage you could get closer: Its MONITOR OUT is stereo by design and independent from the two effect loops.

    However we don't offer such a "super stereo" effect loo. The sends are always mono. However depending on where you intent to place the effect loop in the signal chain it might not be relevant: The PROFILER signal chain is mono anyhow from input to stack. So even if you place your effect loop in module X the incoming signal is still mono.