What is the link line between KemPer and remote? Isn't it a regular network cable? My connection cable is broken. Can anyone tell me how to make or purchase it? I have tried many network cables but they are not working
What is the link line between KemPer and remote?
- bbxxgg817
- Thread is marked as Resolved.
-
-
All CAT 6 ethernet cables are compatible with the KPA and Remote.
Or, you can order one from the Kemper website.
-
I bought this and it works a treat!
I would not recommend going for a longer cable than 20 - 25'
-
From the 10.2 manual:
The cable included in the PROFILER Remote package with its Neutrik® etherCON® cable connector carrier has been carefully selected and is perfectly suited for this purpose. If you decide to use any 3rd party cable, please make sure it meets our quality standards.
The diameter of the wire is the critical factor. The cable delivered with the Remote meets American Wire Gauge 24 (AWG), which can support up to 7.5m (22ft) length. AWG 26 cables have a smaller diameter and can only support up to 5m (15ft). Cables with higher AWG e.g. AWG 28 should not be used with the Remote.
Cables in excess of 10m (30ft) might require a Power over Ethernet Injector (PoE Injector).
-
All CAT 6 ethernet cables are compatible with the KPA and Remote.
Or, you can order one from the Kemper website.
I tried all the CAT5 and CAT6 cables, and when they were linked, the Remote screen flashed and went out.
*edited by mod to set the font size back to standard* -
I tried all the CAT5 and CAT6 cables, and when they were linked, the Remote screen flashed and went out.
Can you try your remote with a different Kemper?
How long are the cables you tried?
-
Can you try your remote with a different Kemper?
How long are the cables you tried?
The controller is good, I just want to replace it with a shorter connecting cable. The original controller cable is usable, it's too long
-
Can you try your remote with a different Kemper?
How long are the cables you tried?
5m,15ft