" Power Sagging " question / clarification re:- Setting it to Zero / 0

    Hi all !


    Whilst I *do* understand what “Power Sagging” does ..... what is not clear is the setting at zero / 0.


    When the “Power Sagging” is set to zero / 0 does it


    1 => remove all “Power Sagging” from the Profile (?)


    or


    2 => does it retain the “Power Sagging” that the Profile has in it, and simply just "not add any more" Power Sagging (?)


    Thanks,

    Ben

    manual p.172:


    With “Power Sagging” set to 0%, the original dynamic range of the PROFILE is maintained.

    When you turn “Power Sagging” beyond 50%, you go beyond what can be achieved with an analog tube amp.

    Hi! When You actulally Do a PROFILE the defalut setting is at 0.

    From Manual (Stack Section pag 171) : ''With “Power Sagging” set to 0%, the original dynamic range of the PROFILE is maintained.''

    So it Does Not Add (or Subtract) Anything from the actual Sag of the Amp You're Profiling.


    From there You can Just Add More Power Sag.

    Again From Manual: ''When you turn “Power Sagging” beyond 50%, you go beyond what can be achieved with an analog tube amp, but without losing any of the natural characteristics of the sound. At full force, “Power Sagging” can make sparkling clean notes sound louder than distorted ones, so you can use it to expand the dynamic range of the original sound.''

    Quote from christianbad

    manual p.172:


    With “Power Sagging” set to 0%, the original dynamic range of the PROFILE is maintained.

    When you turn “Power Sagging” beyond 50%, you go beyond what can be achieved with an analog tube amp.


    Thanks very much .... I definetly missed that :)


    All the best,

    Ben