I am looking to mount my Profiler Remote to a Temple Audio board along with expression pedal and wireless. Yes I know the stage would better suit what I am needing… BUT I would love to have an RJ45 jack that I can plug in a Cat5 to run to the power head. Is this possible? I’ve tried a couple and didn’t seem to work. Is it something in the POE tech? I don’t necessarily need a longer than 35’ run so should a standard connector be suffice?
Remote RJ45 jack / coupler
- jaykrivsky10
- Thread is marked as Resolved.
-
Please consult the Main Manual. The chapter about the Remote includes hints related to cabling and PoE.
-
Please consult the Main Manual. The chapter about the Remote includes hints related to cabling and PoE.
Yes. I have read the section of the manual. However it’s not what I’m asking. I don’t need a longer run. I’m wanting to mount the remote on a board and install a neutrik ne8fdp coupler or similar so that i don’t have to keep the 25’ cable attached to the board or route it through every use. Is a PoE injector necessary to accomplish this?
-
Is a PoE injector necessary to accomplish this?
I have been using the factory Remote cable with a Neutrik EtherCON Line Coupler - RJ45 Female - RJ45 Female NE8FF and a short cable for years, and have had no problems.
-
I too have used both the Neutrik line coupler, and a generic $4 ethernet cable coupler from amazon. The cable used for the remote is of course just a regular ethernet connection, so any coupler should work. You can buy those little D-type modules with passthrough and mount the whole thing under the pedal board.
-
I’m using a Neutrik ne8fdp as part of a custom rack I’ve built for my Profiler.
Works flawlessly.
-
-
G String
Moved the thread from forum Profiler Remote - Questions and answers to forum Profiler - Questions and answers.
