After a cabling snafu at my last gig, I'm going to use all XLR cables from now on. (I've also read that XLR passes a better signal than TRS cable.) So I want to send the Master Output Left signal to my monitor and the Master Output Right signal to the PA, and I want them to be the exact same signal. It's not 100% clear in the Reference manual, can I select the routing for each of the Master Output Left and Right outputs so that they are both Master Mono?
Make Master Output mono?
- burningyen
- Closed
- Thread is marked as Resolved.
-
-
I don't have an official answer but, I have tried it and it does work. I just set the Master Output to Master Mono.
I ended up using the Monitor Out for my in-ears since my personal mixer can't handle the hot signal as well. I use a TS cable and it sounds fine for me. If I ever get a better mixer I would probably use the two XLRs though.
J
-
OK, thanks. (And oops, I meant TS, not TRS.)
-
Master left is NOT the same as Master right, need to use Master mono if you want it that way
-
Master left is NOT the same as Master right, need to use Master mono if you want it that way
Can you clarify what you mean to say here? When I switched the output on Master Out to Master Mono, the L and R XLR outs sound the same to me. If I switch it back to stereo there is a clear difference though.
J
-
Can you clarify what you mean to say here? When I switched the output on Master Out to Master Mono, the L and R XLR outs sound the same to me. If I switch it back to stereo there is a clear difference though.
J
Uh...yes. Whe are saying the same thing...
-
Cool man, thanks! Just making sure I'm not losing my mind. It's been known to happen.
J
-
No need to split the main outputs.
We have a dedicated monitor output for that purpose. -
I got burningyen wants to use a balanced signal?
-
I got burningyen wants to use a balanced signal?
That was my understanding as well...
-
Yep, I'm done with TS cable.
-
I'm using a DI-Box which I put into the back of the KPA. So just a short TRS cable is needed from the monitor out to the DI-Box.
But I agree, having a balanced monitor-out would be better. Less cables and connections that could fail. Thats why I always try to keep my setup as simple as possible.