FCB two way communication

Akkan · Jun 25th 2013

I've tried the new uno4kemper chip including two way communication, but it doesn't work correctly. I've programmed the Switches 6,7,8,9 and 10 for Stomp C, Stomp, D, X, Mod and tap tempo. If i switch to any performance for example the LED on Switch 6 (Stomp C) is on, but there is nothing into Stomp C. If i switch it off, go to another slot into the same performance and back the LED is still off. If i Switch to another Performance and go back to the last Performance the LED for Switch 6 is on again.

Has anybody a solution for this Problem?

Ingolf · Jun 25th 2013

Are you using two midi cables?

Akkan · Jun 25th 2013

Yes, i'm using two midi cables. Allworks fine. I can Switch all what i want, but the LED status is sometimes wrong.

Gizmo · Jun 25th 2013

Happened to me too on an empty stomp slot. The LED lit up on my FCB

troynova · Jun 26th 2013

Just to be clear this is happening in performance mode?

Does it happen in browser mode with the same rig?

I remember this happening to me once but it was my error
The stomp assignment was wrong.

Gizmo · Jun 26th 2013

Just checked it again and it is in performance mode and is repeatable. The stomp slot was empty.

Browser mode for this rig (Morgan AC20) has different stomps and it didn't happen.

I put a stomp in the slot and the problem went away.

Couldn't figure out how to make the slot empty again.

Went to an empty Performance and tried it.

I can make every stomp LED turn on by pressing the stomp button, even though the stomp is empty.

troynova · Jun 26th 2013

To make the stomp empty again select it and scroll with the type nob to the very beginning there's a empty space it will be say empty now.

Yes the FCB foot led will turn on and off even if the stomp is empty.

It will remember this state even if you go to another rig slot and back.

Akkan · Jun 26th 2013

Quote from troynova

It will remember this state even if you go to another rig slot and back.

That's right, but if you change the performances the FCB doesn't remember the states. After you go back the LED is on on again on an empty slot. It isn't a big problem but a little bit annoying.

Gizmo · Jun 26th 2013

"To make the stomp empty again select it and scroll with the type nob to the very beginning there's a empty space it will be say empty now."

Thanks troynova, I always forget about the TYPE knob, I was trying to do it with the BROWSE knob.

Share