Hey good people of Kemperia.
Does anyone know how I can send midi from computer (Cubase->MidiOut->MidiIn) and/but still use the FCB1010 at the same time?
I got Cubase running my rig switches live/stomps/effects, it works great, AND I have no latency, finally 
. But it's also nice if I could have a backup plan if something goes wrong with the computer. 
I run an almost identical setup, and use the exact unit above. Its very expensive for what it is, but as far as i could see there are no alternatives.
If the KPA FS ever arrives, it should work on cat5 and free up the midi port.
I run an almost identical setup, and use the exact unit above. Its very expensive for what it is, but as far as i could see there are no alternatives.
If the KPA FS ever arrives, it should work on cat5 and free up the midi port.
Do you ever have any issues with latency, especially on your wahs?
Never used wah in my entire life. There is a slight delay when switching patches with the KPA on performance mode, the midi switching box/FCB1010 doesn't increase this.
have you tried to slave it through? Audio interface MIDI Out -> Kemper MIDI Through to FCB 1010 MIDI In send back via 1010 MIDI Out to Audio Interface MIDI In.
You will have to address your devices on separate MIDI Channels and you are done. Complete 2 way communication.
Good Luck!
I think you can get those boxes for cheaper. It's just a midi merge box. Here are some cheaper ones:
http://www.ebay.com/itm/Midima…pment&hash=item19eacac5f1
http://www.ebay.com/itm/anatek…ain_2&hash=item23382fdc27
http://www.ebay.com/itm/MIDI-m…nects&hash=item19e9caeffa
Lots more options available that won't cost you 75 pounds.
Display MoreI think you can get those boxes for cheaper. It's just a midi merge box. Here are some cheaper ones:
http://www.ebay.com/itm/Midima…pment&hash=item19eacac5f1
http://www.ebay.com/itm/anatek…ain_2&hash=item23382fdc27
http://www.ebay.com/itm/MIDI-m…nects&hash=item19e9caeffa
Lots more options available that won't cost you 75 pounds.
Yeah, these will absolutely do.
