Better Main/Monitor EQ in the Output section

    I feel the amp-like EQ of the main/monitor output a little bit too light...
    I think a parametric or a graphic EQ (such as those we already can use as stomps) would be much useful !

    At least, a simple low cut and high cut...

    What do you think folks ?

    Looks like only shelf/cut filters are confirmed, something more detailed would be very nice though.


    High pass/Low pass filters in the Output EQs

    Disclaimer: When I post demo clips for profiles, there will be some minimal post-processing, unless stated otherwise. I normally double-track hard L/R, and add to the main buss a small amount of EQ and a limiter/comp set pretty light as well. Sometimes I get test profiles in advance of release, though 90% of my clips will be from packs I have purchased.

    Like 2

    Hi- and Low-cut will help a lot, but to have an impact on the remaining and important mids, a grafic or parametric EQ would be highly appreciated.

    Also storable Volume Levels of the Output-sections would be very nice.

    Quote from JoSeven

    I need a proper Parametric EQ man. The filters aren't useful to me at all as I'm looking for specific frequency modifications. I think this is a feature long over due.

    I've asked for this the past few years. Anything short of PEQ is useless for me for monitor out.

    The key to everything is patience.
    You get the chicken by hatching the egg, not by smashing it.
    -- Arnold H. Glasow


    If it doesn't produce results, don't do it.

    -- Me

    Like 2