The MIDI controller I bought along with the Kemper is very simple - a Tech 21 Mongoose. The buttons speak only program change, which is fine if I'm configuring for a gig. Load the profiles I want, set the PC, ready to rock.
Most everything else in the MIDI implementation is CC or NRPN. I was wondering if there were any tricks / configurations that would allow me to map some of that to respond instead to PC. As an example, since the pedal only speaks PC, it would be great if I could program the browse next / prev to a couple of PC values.
This is a long shot I'm sure, and I know the most supported solution is to spend $469 on the foot controller, but that's a bit of overkill for my typical needs, so I thought I'd ask.