When it comes to the noise gate, where in the ”chain” should I put it? Can I also add to noise gates in different positions to get even better noise gate-effect (I have problems sometime with feedback although using noise gate in the Kemper).
Perhaps noise gate in the pre-amp section (if possible) and afterwards in the effect chain?
Thanks in advance!
/Rickard
I try not to use one at all, but if I need it then it goes in front of everything.
Try what works for you but I use mine in the pre effects section.
No point having 2 on, mine is silent even on very gained profiles.
Make sure you are careful how to set the threshold and feedback should still be obtainable.
Note: Its a stomp effect so if you are struggling getting musical feedback, you can temporarily switch it off...
There is a support FAQ as well as the chapter Noise Gate in the manual explaning the domains of the input noise gate versus the effect noise gates.
Thanks everyone!
