Hey there,
I am really happy about the RigManager software. Especially the feature to instantly listen to the rigs from RigExchange is great!
But unfortunately everytime I start the program it starts to (re)sync all the rigs from the connected Kemper.
In the manual it is written that this would only happen at the first start of the program, but it happens at every start.
And it takes a looooooong time... maybe around 20 minutes (there are ~380 rigs on my Kemper atm.).
In this time, I can load other rigs from the RigManager (but it takes ~5 seconds until they are loaded up in the Kemper), but I can't do much on the Kemper itself because the sync.-screen is in the way -> I can't see what's on the display.
Even if there are no changes to the rigs on the Kemper, they all get synchronized agian and again everytime I open the program.
I had that problem with the first beta and i also have it with #2.
My system is a desktop PC with USB2, Asrock Mainboard, Windows 7 Ultimate 64bit. RigManager is installed on a Samsung SSD hard drive.