Hi guys,
i received my uno4kemper fcb1010 chip last week, and nearly every thing works fine.
But i don´t know, how to use the wah pedal. Do i have to use specific slots or is there anything, i have to set up before using the wah pedal?
Thanks a lot
Hi guys,
i received my uno4kemper fcb1010 chip last week, and nearly every thing works fine.
But i don´t know, how to use the wah pedal. Do i have to use specific slots or is there anything, i have to set up before using the wah pedal?
Thanks a lot
I'm in the same boat as you. I just haven't had a lot of time to look into it. I think that we have to configure the pedal on the FCB and then there are some sweep adjustment settings in the Kemper to setup. Perhaps someone could post a few tips for this? If not...then on to some reading.
First, go here: http://www.behringer.com/assets/fcb1010_p0089_m_en.pdf - page 12 has instructions for calibrating the pedals. The part about "if you have version 1.4 or higher" does apply to you, so you can follow what it says for that.
After that, it's just a matter of adding one of the wah effects to any slot you want (usually one of the Stomp slots) and making sure the Pedal setting is set to something other than Off or Touch. Alternatively, if you select a stomp slot by holding the button, you can turn the Browse knob to look through effect presets. Way, way at the end of the list you'll find the ones labelled WWAH, which are the basic wah pedal presets.
At first you have to do a calibration of your FCB pedals according to the manual.
Secondly put a Wah in (preferably) slot 1 and switch it on.
It should work now without any further configuration.
EDIT: Lokasenna beat me to it.
damn -.- ...the solution was so easy, i have to apologize for this question
Thanks a lot, guys
Don't apologize , It is a simple ,but confusing thing.
Thanks a bunch for the quick info, Gents! Much appreciated!
First, go here: http://www.behringer.com/assets/fcb1010_p0089_m_en.pdf - page 12 has instructions for calibrating the pedals. The part about "if you have version 1.4 or higher" does apply to you, so you can follow what it says for that.
After that, it's just a matter of adding one of the wah effects to any slot you want (usually one of the Stomp slots) and making sure the Pedal setting is set to something other than Off or Touch. Alternatively, if you select a stomp slot by holding the button, you can turn the Browse knob to look through effect presets. Way, way at the end of the list you'll find the ones labelled WWAH, which are the basic wah pedal presets.
Huge help.... thank you. Spent hours trying to get this, and all good now.