I posted this before the forum went down, but lost it 
When I switch rigs in browser mode via midi, everything is pretty tight. When I do it in performance mode, there is no gap of silence, but the change takes quite a bit longer.
Anyone else getting this? Latest beta firmware and a Behringher FCB1010. It does it with the front switches too though.
They have improved it a lot with the last firmware in performance mode. I was having almost half a second delay between slots and now it's definitely shorter. I haven't tried it in browser mode though.
No delay with a generic midi controller. It's not even close to have a second, maybe a third of that. Are you sending more than one message? Also, are you getting any popping or clicking sounds when you change performances?
I have very very fast switching here.
I think you're not.
It seems differences across the units do exist, This would explain a good amount of the endless discussions about people "hearing things".
Performance mode switches instantly here, both via the unit and an amp's pedal.
What would be handy is a feature where ; if you stomp the up or down switch twice in Performance that it goes straight to the rig 2 slots up or down rather than having to hear the slot in between when you're playing....this is on a simple up & down switching pedal that I use on performance mode for one of the bands I'm in ( does this make sense ? )
My changes in performance mode are very quick now, there used to be a little lag but CK improved this is a FW upgrade recently, are you sure your FCB is not sending multiple messages
It does it even when I use the buttons on the front panel and when USB and the FCB are not connected. It's nothing to do with the FCB.
I would contact support then, as this is not normal
