Issue with Cabsection when profiling under 3.0.1 Beta

TheLightspeeder · Mar 21st 2015

Hi All,

I tried to profile a few amps with DI profiles and then regular mic'ed set-up. I did one DI and one Mic'ed but then when I tried to do some more profiles with mics, the cab section was always switched off after completing the profiling process and I also could not add a cab from the cab section as this section was not letting me do any changes...it was stuck. I did a system reset, checked in outs, cables etc...nothing. So, now every time I profile, the profile is Amp only, no cab sections.... anyone noticed that or has experience with it?

Thanks!

G

TheLightspeeder · Mar 22nd 2015

Anyone?

Michael_dk · Mar 22nd 2015

<p>Those profiles, can you hear the CAB in them?</p>

TheLightspeeder · Mar 22nd 2015

No, it sounds like a DI profile. And I can't add a cab...the cab LED section is off and when I call it up, is completely unresponsive and I have to do a reset. Now all my profiling tries end up with the cab light off...

Michael_dk · Mar 22nd 2015

Stupid question, I know - but are you absolutely sure the right cable is connected to the kemper's return when doing the profiles? I.e. the mic rather than the DI box?

TheLightspeeder · Mar 22nd 2015

Yeah, I had initially thought so too...but I double checked cables, connections and even changed out mics...plus I disconnected the DI box as well to be sure to not make a mistake

deadpan · Mar 22nd 2015

Just had this happen. 5 profiles fine then this on number 6....

All was fine until I exited refining and then it turned to a no cab sound. Should have saved the file...

TheLightspeeder · Mar 22nd 2015

Have you been able to reset it and get it working again? Mine is still not profiling right....

deadpan · Mar 22nd 2015

I gave up. I went to browse mode and the first 2 were fine and the other 3 sounded fine but had the cab disabled. I deleted and will wait for the next firmware. I believe Kemper is aware of this from other threads.

TheLightspeeder · Mar 22nd 2015

Oh I see. I tried for a few hrs yesterday to get it working but gave up too... I haven't seen this happening as described yet in the forum or was it and I missed it...? Anyways... Wanted to profile some new cool amps but I am in the road and won't the able to do it again with these now.

meambobbo · Mar 22nd 2015

Does it matter which profile you have loaded when you start the profiling process? Try loading a studio profile instead of a direct profile, then try to create a new profile

TheLightspeeder · Mar 22nd 2015

No, I loaded all kinds of different profiles to start off with and no difference; same behavior...as of now, my profiling process isn't working correctly at all.

djemass · Mar 23rd 2015

Hi

Have you opened a ticket ?

Just to make sure Kemper team has well the information...

Last month, during the FW3.0 "crisis", I remember Kemper team was very busy and didn't have much time to go to the forum...

40661d4ade5602bab6d4c5f085c0e61f79738f31 · Mar 23rd 2015

I think it is a known issue (it's the 1st from 3.0.1 changelog), the profiler sometimes doesn't recognize if you are creating a studio or a direct amp profile. Contact to support nevertheless.

TheLightspeeder · Mar 23rd 2015

It is a known issue? I gotta go back and read the release notes again. I'll open a support ticket and see what they say and post the findings here. Thanks!

Share