Stand for Kemper Head and QSC K10 idea

I was looking at trying to put together this stand:

https://on-stage.com/products/view/11181/117060

and this mic stand mount shelf to attach to the stand to hold the head:

http://www.amazon.com/OnStage-…aptop-Mount/dp/B00V3A619U

the laptop shelf has a 12lb weight rating which is right there at the weight of the head.

Im hoping to find a highly portable stand to hold both while it angles the cab towards me, lifts it off the ground (in case my basement floods again), and puts the Kemper at mid height for easy tweaking. Anyone have experience with either of these or any other ideas?

Actually I hadn't considered it completely, the picture looks like it stands pretty far up right. I did call the company and they said it has a pretty strong angle but then recommended that if I could find this part it should work for me. I want to head and place the order for all three, this part should straighten out the shelf and is all metal construction so it should be strong.

http://www.bhphotovideo.com/c/product/400142-REG

I did try that one out, unfortunately it doesn't fold much to be very portable, otherwise it was decent.

Ill post a pic of the new one when it comes, should be in a few days. The quiklok and the other one aren't quite the right function/size but thanks for the suggestions.

Ok so here are my observations on both stands:

Quicklock: Its solid, head and k10 fit on it ok, unfortunately the legs are not able to be locked, they are fully open only, however the weight of the cabinet keeps them in place for the most part, not sure if so with a lot of decibels pumping. This means that they get in the way of the cabinet connections and can't be locked into a position that doesn't interfere. The arms of the upper shelf are exactly the width of the kemper. It feels like it will stay but if someone were to bump it, I could see it falling off so you might want to put some kind of shelf under it if there is traffic around where you set it up. Folded it is flat but wide and so it won't fit in my bags I use for mic stands, guitar stands and drum stands. The bag is a designed for speaker stands and drum stands. It seems like this would hold up for a while, just wish it wasn't so bulky.

On-Stage with shelf - It is not as solid feeling, much lighter gauge metal and more plastic. When setup it held the kemper and k10, though the laptop shelf was a little wobbly and has a bit of a bend to it with the head and all the cables attached. I suppose the head with cables goes above the weight limit so I am a little nervous to leave it up there. The part that holds the cab seems ok, though there was a little creaking when I put a little weight on it, might have just been cause it was new. I think this would be fine to hold the cabinet or the kemper on the lower shelf but I don't think I will keep it setup with the kemper up top. The stand folds up really small and the shelf detaches so it would make a great portable setup if the shelf had a better weight limit. Its seems like it might break over time if gigging, but it is pretty inexpensive too.

If you care to see photos of the two, here is a dropbox link:
https://www.dropbox.com/sh/j9b…tGqfNcM4De_qm6-JNgqa?dl=0

Overall I am probably going to keep looking for a two shelf system that is portable.

Quote

ive got the quik lock bs 625 and i took the upper part of the stand and flipped it around so the arms are the longer ones that the kemper sits on. it works great like this used on many gigs no problem with stability.

I just tried it, seems like it could work but it sets it further back behind the cab this way, so I switched it back. I am still considering the quiklok since its pretty solid.