Cool thanks. I'm kinda thinking about getting a black anodized piece of aluminum with holes drilled for the feet and maybe handle area (aka JEM guitar) to protect the cable jack. That would weigh next to nothing but keep all the bits together so they wouldn't slide around. Will post if I can figure something out...
Post your Remote/Pedalboard/Switcher Setup
- dallasclemyck
- Thread is marked as Resolved.
-
-
A sheet of aluminium is easy enough to get from any metal supplier or even ebay. Getting one with holes would be harder. However, aluminium is pretty soft so you can easily drill holes of any size you want at any location you need with just a regular diy hand drill and a few cheap metal drill bits.
-
Ikea Henje shelves are are a great ikea hack to make a pedal board.
-
Here the images of my Remote pedalboard. I needed a wider width for 3 Pedals and the remote.
After looking for various solutions I finally I took the Thomann Harley Benton SpaceShip 80 boards, cut away about 10cm out of it to fit the length of the volume pedals.
With the rest I got a 80X12 cm pedalboard that will go to Ebay soon
On the left and right side I attached some handles to carry it on easier.
It was difficult to attach the Velcro on the Mission pedals. I used the Thomann Harley Benton SpaceShip Wah Fastener and a visit to to a shop selling all kind if screws helped me to fix those to the pedals and the pedals on the board.
See some pictures below.