I am trying to run the main out set main .mono out to interface FIRESTUDIO AND ALSO MACKIE BIG KNOB but both sound out of phase or hollow put when i use headphone of the KEMPER SOUNDS great.On the cables I use are regular ts 1/4 or xlr.I use the monitor speaker out to Marshall cab and sounds fine,Just the Main out sounds hollow either going to interface or mackie big knob.I have set the lacency on the KEMPER.Is this a routing problem? Thanks Bruce
MAIN OUT TO INTERFACE SOUNDS OUT OF PHASE
- BRUCEHEARN
- Thread is marked as Resolved.
-
-
In output section set constant latency off and for testing switch all effects off.
Maybe you have a stereo effect which sounds in mono different? -
So you're sending one side of the mono signal to your interface and the other side of the mono signal to the mackie big knob or what?
-
just one from the main out either the interface or mackie but not at the same time
-
can you post a recording?
-
does the recorded track sound like this too?...or just when your monitoring through the daw