Hey Guys,
Im really struggeling dialing in the high end of My tones. Especcialy the high gain ones.
I always feel like there is hiss/ fizz in them from 2k untill 8k. And cant dial iT out.
How do you Guys approach smoothing out your high mid to high end?
Eq before Amp?
Eq on AMP?
Defenition control?
High and low settings on cab section?
Eq after AMP / cab section.
Tried them all and cant seems to get the results im after.
Any suggestions welcome! Thanks Guys.
I would try out other cabinets (from other profiles) as well
What speaker are you using to listen to your KPA?
I like using the graphic EQ in the X slot; I have found that (specifically for treble) I get good results with setting the high cut around 8500hz and dropping the 10k band to -2 to -5dB. For whatever reason it still effects the tone even with the high cut set as such. I typically set the mix to around 55-60%.
Then if needed, I throw a Studio EQ in one of the pre slots and notch filter any trouble frequencies. Mix around 65-70%.
Trying out other cabs can be a huge improvement too.
I use a high pass filter to chop off everything over about 6500hz
Im using hedd07 in studio setup.
What cabs do you Guys suggest??
I OWN ownhammer ir and tills cablab.
Not finding What i seek.
Awesome tips on tweeking. Goin to try.
I don't use high-gain rigs very often, but my experience has been that they don't play well with FRFR setups where tweeters are involved. I suspect that coax speakers, or one where the tweeter can be switched off, will give you better results.
I love turning down the High Shift parameter. It’s in the Cabniet menu. To me, it sounds a lot like moving the mic further off center
