I'm a newbie to Midi. I have bought a Morningstar MC8. I seem unable to get my kemper Stage to follow the CC I'm sending. Anybody have (simple) instructions to get them to connect please. I'm sure I have them both on channel 1.
In the MC8, bank 1, preset A - I have Toggle Mode on - press Control change cc 29 cc value 0, then press Control change 29 cc value 100.
The Midi Monitor from the Midi Editor shows the request sent - but the Stage does not respond.
Harle
Have you checked that the Kemper and Morningstar are set to the same channel for midi messages?
Make sure that the MIDI Global channel of your Kemper (in System MIDI Settings) is set to MIDI channel 1. Make also sure the MIDI cable is correctly connected (MC-8 OUT to KPA IN). I know that it's obvious but we all do simple mistakes like this. Make sure that your MC-8 send the CC message to channel 1. I personnaly use CC29 value 1 to put the reverb ON and CC29 value 0 to put it OFF.
