I am running a Kemper to a EH Magnum 44 amp then to DrZ 2x10 cabinet and the volume is way too loud .
Is there controls in the Kemper to cut back the volume before it gets to the EH Magnum 44 amp ?
Thanks in advance - Cheers
Kemper to EH Magnum 44 amp to DrZ 2x10 cabinet way too loud
- MichaelWalsh
- Thread is marked as Resolved.
-
Which Kemper output are you sending to the amp? Any line level signal into the amp will be too hot.
-
Sorry I have to ask this, but did you read the manual?
-
Which Kemper output are you sending to the amp? Any line level signal into the amp will be too hot.
This.
-
Using the Monitor Output
Then you'll need to adjust the monitor output value in the Output section. You can even link this to the master volume so you don't have to dig into the output section each time.
