Hey community,
I often like to be "sound-surprised" by changing cab sims.Recently I bought a nice Direct Profile (from SuckerFreeGear - Cameron Aldrich 1.05)
and want to use it with FRFR instead of a real cab (where it's necessary to push "Merge Cabinet" soft button).
To scroll through cabs saved on KPA everything works fine (doesn't matter if Presets or From Rigs).
If I want to try different cabs from a library via rig manager "Merge Cabinet" is not shown.
Here is how I did it :
1) load the DI-Profile that is saved on Kemper
2) lock stack section ( amp & eq only )
3) load a rig (cab) from rig manager that saved on pc or re = no "Merge Cabinet" soft button , sounds horrible.
If I load the same rig (cab) from pc or re again and save the cab on kemper = "Merge Cabinet" is shown , can be pushed and sounds good.
I'm a bit confused. I mean why my kemper insists that cabs must be saved on KPA itself to try it with a Direct Profile?
Perhaps that's the way it was meant to be - then I could live with... but it's so laborious.
If I understand or doing something wrong, please correct me and advices and suggestions would be appreciated.
Thank you in advance!