Parallel Path only works with Stomp A + B. This was okay before long time. I think it would be nice to put all Stomps (A-D + 1-4) have the Stomp specific setting to put in a parallel path.
Parallel Signal Path in all Stomps
-
That could be nice but for me even more important would be to chose where the parallel path re merges. At the moment it is only right at the end of the chain but it only be great to b able to hav it merge before delay and reverb for example.
-
As I recall, the parallel path is primarily for bass.
-
Parallel paths for all the blocks but especially for Reverb and Delay (there it makes the most sense for me) would be THE coolest new feature.
-
Parallel paths .... especially for Reverb and Delay (there it makes the most sense for me) would be THE coolest new feature.
that (and a lot more) is already possible for a long time. check out manual page 266:
DLY+REV Routing (in Rig Settings)
-
that (and a lot more) is already possible for a long time. check out manual page 266:
DLY+REV Routing (in Rig Settings)
Yes, you can. What I meant is more like... a shimmer, a hall reverb and a delay (or different or more fx) - all three (or more) in different parallel paths - kind of thing. I'm not sure this works but to be honest I use the fm9 for these kind of complex applications and haven't tried the Kemper fx so much.
-
On the VST I am writing I have the parallel path merge right before the Amp.
This lets me have a high freq gain path and a low freq cleaner path.
The cleaner path adds dynamics when you dig in hard. Sounds really good with stereo chorus as well.
Having them combine before the amp lets you smooth out the difference between the two tones.
Basically I am a fan of any additions to the parallel options.
-
As I recall, the parallel path is primarily for bass.
That’s definitely hpw it was originally intended but there’s no reason it should be restricted so that bass players get all fun 😁
