Hi,
This is a feature request for a small, but very annoying issue that my KPA has at the moment. When I power it down, just at the last second it gives a rather obnoxious and kinda loud poping type noise.
Would it be possible to mute all outputs during the power down sequence so that this doesnt happen?
I got the fright of my life the other night.... I had my KPA setup into my interface and had finished recording the guitars for a song. So then I decided to do a backup of my rigs just to be safe (I do this every 2 months or so) and it left it to do its thing as I went about other DAW-related duties. I forgot about the KPA until later, when I was powering off my session and I wanted one last listen before I shutdown my computer. So I turned off my KPA and quickly sat back to a relaxed silence.....then...
bu-bu-bu-boPOPPPPP!!!!!
I swear I wasnt expecting that, as the mix was recorded with lower levels yet the KPA track in my interface mixer was up full and I nearly jumped through the roof!
Anyways, just a small request. Thanks