Hello,
till now I did not find the trick to get infos about center frequency and bandwitdth parameters of the EQ controls in the Stack section and where to set.
Can it be changed and stored (global or for every RIG)?
Thanks for infos,
G.
EQ parameters in the Stack section?
- Goodwin
- Closed
-
the EQ in the Stack section is our version of a typical tonestack - and it sounds quite good!
switching it pre and post the Amp slot can give you additional ways to form the distortion (pre) or overall sound (post).simply use a Studio EQ or Graphic EQ pre or post the Stack section for more options, including frequencies and Q.
-
Thanks for the reply.
But can you say me, what are the actual values of the controls, e. g. the center frequencies for Bass, Mid, etc.?
The manual says "Mid controls the mid frequencies". Very surprising
In the datasheets of all my other devices one can read data like this:
Mid Control: center frequency xxxx Hz, +/- yy dB, bandwidth zzzz Hz (or 1/n octaves)Maybe you can ask the developers, what they programmed
Best regards,
G. -
someone in this forum did make measurements, but if I've learned one thing in the years of recording, mixing and performing:
never trust numbers, trust your ears. -
If you think of this thread, that was about the Output-EQ, not the Stack-EQ.
-
CKemper has chimed in and said there are no precise center frequencies for the stack EQ, because each control affects the others. However, here's a basic synopsis:
http://www.wikpa.org/Signal_Chain#EQ_Slot