Stock Profiles

There are approximately 462 Factory Rigs included with v3.0x firmware.

Wow, lot of different answers.

The very first thing I did when I first powered up my brand new KPA Power Head, back in April, was make a backup file on my USB Flash drive.

I just looked at this kpabackup file, using 7z. There are, of course, a bunch of folders in the kpabackup archive...however, I believe the salient one is the folder labeled "Rigs". I opened this folder, and it contains exactly 296 .kipr files, which are the factory installed profile/rigs.

I believe the firmware was 3.01, out of the box. After I made the backup file, I upgraded to 3.02.

Now, I leave it up to the Kemper guys to advise if the backup file includes the totality of the "factory installed" profiles...or if the is another set of profiles that do not get copied onto the backup file. Specifically...I am unsure about the rigs that would be "imported" when you go to the System menu, and go to the page where you can select the "Import Factory Rigs". I didn't make a note of how many Rigs appeared in the "All Rigs" display, when I first powered on my Kemper. I am pretty certain that the entire population of "All Rigs" gets saved in the backup file, and appears in the sub-folder "Rigs". However, I am uncertain if the rigs that are permanently on the KPA, as part of the Firmware, and require the manual decision to "Import Factory Rigs", are also included in this backup sub-folder. If these "Factory Rigs" are not copied onto the backup file, then the total number of factory installed rigs on my factory new, pristine KPA would be = (296 + X number of rigs from the Firmware/Factory Rigs).

Perhaps this is how Paul arrives at the 462 number.

It is not such a rudimentary question after all

I counted the number of rigs in the April 21st version of the document included in this thread (it has been revised on May 11th):

http://www.kemper-amps.com/for…st-revised-May-11th-2015/

The document includes the contents of the downloadable "Rig Packs" - I assumed they were included with new Kempers, and downloadable for the rest of us.

install newest firmware....press system button...go on page 1....4th button on the top says "factory rigs"
this will bring up all factory rigs

have fun!

Quote from paults

The document includes the contents of the downloadable "Rig Packs" - I assumed they were included with new Kempers, and downloadable for the rest of us.

Not all of the rigs of a Rig Pack get necessarily included in the factory content all the time.

As to the the original question: I don't care als long als they are available online.
Also note that the number of factory rigs has changed over time and some ended up in a legacy pack.

The number of factory rigs is different with most firmware updates as we might add or take away some of the rigs in a new release.
The current number of rigs is 337.
All of the rigs that were ever part of the factory content can be downloaded from our website as the so called legacy rig pack.

you beat me by 3 minutes!

Quote from hjscheffler

you beat me by 3 minutes!

So it goes.

well at least i had the correct number......

You two, stop liking each other!

Quote from viabcroce

You two, stop liking each other!

Oh, we like you, too.