Request for a new signal feed output option

    Hi


    I'd like the ability to run the Kemper as part of a wet/dry rig in combination with a physical tube amp. At the moment I use a Axe FX Ultra in a wet/dry set up with my tube amp. I send my guitar through some choice ODs, into the Ultra where I might add some other effects. I then split the signal with one side going out of the Axe FX and into the front end of my tube amp and 2x12 cab. The other part of the signal goes through an amp and cab emulation ins the Axe, and perhaps some delay and verb in the Axe and out to a FRFR DXR10.


    If the Kemper had the ability to run this sort of signal chain I would definitely switch to using it, as having played it I love the amp sounds I was getting.

    Maybe i am misunderstanding your post but from i read you can do exactly that already with the Profiler. The signal that enters the Profiler is present at the direct out in several varieties (git/analog, git/studio, git/processing) from there you go to the external tube amp. The input signal of the Profiler will also be processed by the Profiler and you can send it from the main outs to the FFR monitor.

    He's (see his other thread) actually asking for a Direct out output taken after the Stomps an before the Amp. Currently, the available options are pre-Stomps or post-Amp.


    Correct, e_m?
    :)

    Quote from hjscheffler

    Maybe i am misunderstanding your post but from i read you can do exactly that already with the Profiler. The signal that enters the Profiler is present at the direct out in several varieties (git/analog, git/studio, git/processing) from there you go to…


    Yes i read about those in the reference manual. From what I could gather none of those options would allow the signal to be processed by the first four stomp slots. It will only take the pure guitar signal and either output it directly unprocessed, or subject it to AD conversion and vary the output level for git+processing and git studio respectively.


    I want to be able to run my signal through those first four stomp slots, then tap off a feed from there to run out to another tube amp and cab as my dry sound, and the remaining signal run through the stack section of the Kemper and the mod section and out to a DXR10 as my wet sound.



    Quote from viabcroce

    He's (see his other thread) actually asking for a Direct out output taken after the Stomps an before the Amp. Currently, the available options are pre-Stomps or post-Amp.


    Correct, e_m?
    <img src="http://www.kemper-amps.com/forum/wcf/images/smilies/smile.png" alt=":)" />


    Viabcroce you are correct :)

    I could imagine setting up a loop in Stomp D, splitting the signal with a y-cable and feeding one line to your tube amp and the other back to the Profilers Return Input. You would sacrifice one Stomp though.