SOLVED 4.0.4 Install Error

Try re-downloading the update.

I think there is an issue with the file on the web site. I downloaded it twice and it does not even recognize that the file is on the usb stick.

Drog - have you unzipped the file, and put it in the proper directory on the u s b?

Yup same as I always do

I've just downloaded, unzipped the file, put it on my USB stick and pressed go....... my kemper is now re booting after the update without any problems.

MC

Reformatted my usb stick, re-downloaded beta 4.04, put usb stick in Kemper...yay! Recognized finally.
Update completed, running fine so far.

hi Drog...for the benefit of the whole community it is a good thing to edit the subject by adding SOLVED on it so that the readers can check it out faster and better

anyways, good that you could solve it

Quote from michaelmellner

hi Drog...for the benefit of the whole community it is a good thing to edit the subject by adding SOLVED on it so that the readers can check it out faster and better

anyways, good that you could solve it

I agree, except it is not my thread.

I just downloaded and installed 4.0.4 and received the following:

DSP Error!
Communication with DSP board has failed.

???

Prior to installing, my strobe tuner stopped working and my INPUT LED was not registering input. I rebooted and the LED came back, however, no strobe. This is why I went to the 4.0.4 update, hoping it'd reset/fix the issue.

EDIT: Now I've got nothing...no input LED...nothing. Channels change and stomp buttons are working, however, nothing on the input. HELP!

Hi all !

I know its a bit of a trivial thing .... but does 4.0.4 Beta boot up any faster than 4.0.X .... ?

For me, 4.0.3 takes about 01m 10s to boot up and I run only a hand full of profiles and only 2 cabs installed on my Kemper

Ben

DSP error is likely a hardware issue. I had the same issue with my first Kemper, and had to swap it out for a new one.

Quote from brianiac5150

I just downloaded and installed 4.0.4 and received the following:

DSP Error!
Communication with DSP board has failed.

???

Prior to installing, my strobe tuner stopped working and my INPUT LED was not registering input. I rebooted and the LED came back, however, no strobe. This is why I went to the 4.0.4 update, hoping it'd reset/fix the issue.

EDIT: Now I've got nothing...no input LED...nothing. Channels change and stomp buttons are working, however, nothing on the input. HELP!

Display More

Contact support - see link in my signature

Quote from drog

I agree, except it is not my thread.

way da go, my friend!

take care