How do I program two reverbs into one profile? I just got my Kemper and having a hard time figuring it out. I need a short reverb that’s always on, and a longer reverb to use at my disposal.
Two Reverbs
- Mike082377
- Thread is marked as Resolved.
-
One option you could use the morph feature.
-
Program the delay to have long repeats and the Smear parameter turned up? I believe there's one of the new delay presets that is more a long reverb than a delay. Otherwise, you could use morphing to control the reverb length.
-
The only slot that can have a Reverb in it is the Reverb slot.
But, as said above, you can use the Morph function:
If you decide to use a Morph switch in the Rig, it will give you a second set of Reverb settings within the Rig.
If you use a Morph pedal instead, you can can also get Reverb sounds "in between" the heel and toe settings of the pedal.
-
There's also the possibility that a firmware update will allow more than one to be used at the same time, as happened in the case of delay.
-
Depends how short a reverb you want, but you can use "Space" in one slot and the Reverb in the reverb slot
-
You can add an additional reverb device via slot X.
At the moment the last slot is only possible for Kemper reverbs. -
Morph as has been said.
