Hi guys, I'm still less than 3 weeks old with my Kemper Stage and learning more and more everyday but one thing that I am sure is as simple as finding the right setting perhaps(?) is that when I'm recording into a Digi002 / PT10 setup a vast majority of profiles just sound really "grainy and fizzy", even some of the cleaner amp types have some grain to them and I find myself rolling the GAIN control down but then that kills the character of the profile which is what I was looking for in the first place.
Been running lots of experiments, right now I have coming out of the Kemper into the Digi002
*Main/Monitor
*SEND 1 (for direct signal to re-amp later if needed)
*S/PDF
**So each time I record I have 3 tracks armed; is this overkill?
Bottom line is there a special trick or two to get the higher gain amps to sound nice and smooth?
I poke around in the INPUT, OUPUT & AMP sections of the Kemper and sweep through every parameter like clean sense and direct out signal etc...
I try and rationalize that maybe my DIGI 002 convertors are outdated and need a new I/O but then again IDK? LOL
BTW, I have tried both single coil and humbuckers and find the same result so I discarded the theory of it being the guitar?
Anyhow, would appreciate some insight from more experienced Kemper geniuses, I am certain this question is quite ambiguous as there could be many variables involved.
Thank you