so i have a powered toaster with the Kabinet. For recording my daily noodles with headphones and/or monitors I have this connection setup:
Main Outs L/R TRS ->Master Stereo -> Interface Stereo channel
Monitor Out -> Stack -> Interface Mono Channel
Direct Out -> Guitar Studio -> Interface Mono channel
That way i can record the main noodle mix including Looper (set to post) for listening, and the DI signal and the dry 'amped' signal if i want to use the solo guitar without looper/FX or just the DI signal takes later on.
Now for sure sometimes (during daytime) i'd like to use the Kabinet for listening while i'm playing but the problem i have is that when i enable the power Amp and switch on Kone mode i have to change the outputs settings in order to hear the FX section through the Kabinet, so Monitor out needs to be Master Mono and i loose the abilty to use the Monitor Out as i want.
So basically depending on wether i'm using the Kabinet or not i need to do a lot of switcheroo in thew Kemper menus to switch between output settings or disable the Kabinet if i want to have the ouputs assigned as above.
Am i doing this wrong ? Is there a way to have the Kabinet work in Kone mode and still use the Monitor and Direct outs as independant DI/Stack outs ?
Maybe some of you have solved this issue and found a way to do both without having to switch ouputs ?
PS: Also still haven't found a convenient way to control the volume on the Kabinet when the poweramp is on, my Master Volume knob usually controls headphone volume, so again depending on wether i play with headphones or Kabinet i need to work the menus to find the right volume control. I should probably RTFM again i did RTFM a couple times already and also watched the ouputs video several times but couldn't find a straoightforward solution from that.