Is there a step by step guide anywhere? Can you create a new rig in the Profiler or Rig Manager?
slightly off topic but how do you search on less than 4 characters, like ‘Dr Z’?
‘Thanks
Rig creation help
- RedGuitarsMKII
- Thread is marked as Resolved.
-
slightly off topic but how do you search on less than 4 characters, like ‘Dr Z’?
if i search for Dr Z in rig exchange, i get a lot of results. helps to sort by "amp name".
your other question is so basic, that i don´t know how to respond, but yes, you can create rigs in in the Profiler and in Rig Manager.
What´s your problem?
-
Here is where you can download the main manual(and much more), not the quick start.
https://www.kemper-amps.com/downloads
Here are a ton of their “how to”, -
I searched for Dr Z Z28, all less than four characters. Got every thread containing ‘dr’.
In Rig Mgr, when I click on a rig, see the signal chain, I couldn’t click on an effect or the amp and figure out how to change anything.
The KPA must be connected to change effects.
-
It sounds like you are stuck at a very basic level. Many started there too. View the Kemper videos. Tone Junkie has a few videos of how to use RM also. It seems you need some examples and you will find them on Youtube with a little searching.
-
I have a printed manual.
The printed manual is a short manual. Download Main Manual and read it....
-
The Main Manual is planned to be updated with OS 9.0.
-
I have printed the main manual and rig manager manual.
And you are still stuck in a similar place? I still suggest looking at Youtube examples from Kemper and Tone Junkie regarding RM.
-
The Main Manual is planned to be updated with OS 9.0.
Spoiler....
-
The Main Manual is planned to be updated with OS 9.0.
Noted
-
The Main Manual is planned to be updated with OS 9.0.
This is the most interesting post that I've seen in a loooooong time.
