What is exactly bandwith using delay and how do you use this parameter (or rather not..)?
Dealay bandwith setting
- theplayer
- Thread is marked as Resolved.
-
Legacy delay, right?
-
Good guess!
. If it's set to 10.0 there's no delay left whatsoever. So then what is the point of this feature? -
With Frequency at 0.0, the Bandwidth seems to cut the highs of the delays while allowing the lows of the delays to permeate. So, like an EQ high shelf cut.
-
Center frequency is where the attenuation is applied.
Bandwidth is how wide the hump on either side.
More or less. 😉
-
"The main purpose is to maintain full backward compatibility to Rigs that have been created before the advent of PROFILER operating system 5.0. The architecture of the Legacy Delay is like that of the Two Tap Delay. However, it features a bandpass filter with the parameters Center Frequency and Bandwidth – this is in contrast to the other delays, that all utilize the more intuitive low cut and high cut filter. If you are going for deeper edits of an already existing Legacy Delay, we recommend changing the type to Two Tap Delay, or any other type, by using the TYPE knob. This way, you will benefit from their improved parameter set."