Monitor output issue

    hi




    I've just played a little bit with the output section and found some
    features which I was not aware of. So I attached the monitor out to the
    amp but there's no signal there. I went through the settings and tried
    to change the assignment of monitor out (currently Master Left, tried
    also all other settings). Still no signal. Main out and direct out are
    working. Monitor volume is the same as main volume, also EQ settings are
    the same.




    I wonder if I'm doing something wrong or the monitor out is dead. ?( Any ideas? Firmware version is the last public beta (1.6.0.8079B) - if it matters.




    thanx


    tom

    Press & hold "system" while booting ... should solve the problem.

    MJT Strats / PRS Guitars / Many DIY Guitars -- Kemper Profiler Rack / Kemper Remote / InEar

    :thumbup: Thank you! It works.


    However, another problem came up. ;(


    I set monitor out to master left and direct out to master right. Despite the same volume settings of master & direct outs the volume difference is huge, around 10dB between them. Turning linking on/off made no difference, neither changing the out's assignment to mod or stack. Master outs are OK. So either there's a routing issue inside the unit or I did, again, something wrong. I would very appreciate further help.


    thanx
    tom

    Mh... why wouldn't you just use the Master Out instead?
    On which FW are you? I heard that on 1.6.0 Beta the Monitor Out Boost defaults to +12db.

    MJT Strats / PRS Guitars / Many DIY Guitars -- Kemper Profiler Rack / Kemper Remote / InEar

    main outs go to FOH, direct and monitor outs as a stereo pair to the stage monitors/boxes - that's the idea.


    anyway, latest firmware version doesn't solve the problem ?(

    Update to the release version 1.60 on our webside. That will fix the problem.


    Btw: did you notice a change in sound on the main out, after you performed the system reset? :)