You have to set the output level of your DAW to the profiler, just use a DI track you recorded. Watch input LED and set the output level from your interface so that hard strokes trigger the yellow LED. If the amount of distortion differs from the situation when recoding directly you dial the desired amount of distortion with reamp sense.
Funny you should say that. The recorded dry track that i recorded to reamp with was very low compared to when i normally record i compared to wave forms. Is there a way of turning this up from the KPA?? The SPDIF out was on full and my iput LED was flicking RED on heavy stokes when i played so i dont see how i could have turned the signal up